My forks are back from MH Racing which means I have finally got to the first stage I was really looking forward to – a rolling frame. My own workshop is not as well equipped as I would like with a plethora of paddock stands so for this job a 20 year old Black & Decker Workmate had to do.
Supporting the main frame on the bench and a crate I was able to manoeuvre the back wheel into position which is where I hit my first snag. The powder coat was too thick for the rear spindle to go through. Therefore using a coarse sand paper and Stanley knife I chipped through the coating until the spindle could move in and out freely. From there on the back wheel was pretty much a doddle, given plenty of Moly and some careful persuasion.
Enjoy more Fast Bikes reading in the monthly magazine.
Click here to subscribe & save.
Before: Nearly fully stripped
Spinning the bike around I then slid in the forks, the spindle and the front wheel was in position, the clip ons followed and aye voila! I could sit back and ponder the next move which will take some time, and a hell of a lot of degreaser – the ball ache that is cleaning parts with a considerable build up of crap over their years of service.
Now: A beautiful rolling chassis
Enjoy more Fast Bikes reading in the monthly magazine. Click here to subscribe.